Yocto-Thermistor-C
USB interface allowing to connect up to 6 thermistors, PTC or NTC. All six channels share a commun wire. You can add Ethernet, Wireless or GSM connectivity to this device.
The Yocto-Thermistor-C is an USB interface for NTC and PTC thermistor. It can measure up to six temperature points. Each of the six channels can be configured independently thanks to tables or reference temperatures and β coefficients. The Yocto-Thermistor-C is an insulated device: there is an electric insulation between the sensor part and the USB part.
The Yocto-Thermistor-C is shipped with six tiny NTC thermistors connected to a 10 centimeter wire. You can extend them with any regular electric wire.
All six channels share one contact allowing the use of a bigger terminal and bigger wire (26-16 AWG). If you wish to connect the thermistors in a independent, manner choose the Yocto-MaxiThermistor.
The Yocto-Thermistor-C can also be used as a multichannel ohm-meter.
This device can be connected directly to an Ethernet network using a YoctoHub-Ethernet, to a WiFi network using a YoctoHub-Wireless-g, it can even be connected to a GSM network thanks to the YoctoHub-GSM.
USB cables and enclosure to be ordered separately.
Data sheet
- Width
- 58mm
- Length
- 50mm
- Weight
- 17g
- USB connector
- micro-B
- Channels
- 6
- Refresh rate
- 1Hz
- Measuring range
- 100Ω...500KΩ
- Accuracy
- (Ω) between 1KΩ...10KΩ ~0.1%
typical (Ω) 1% - USB bus insulation
- 31.5
- Normal operating temperature
- 5...40°C
- Extended operating temperature
- -30...85°C
- Supported Operating Systems
- Windows (PC + IoT), Linux (Intel + ARM), macOS, Android
- Drivers
- no driver needed
- RoHS
- Yes
- Suggested enclosure
- YoctoBox-MaxiIO-Transp
- Made in
- Switzerland